Search Results for: heal

AutoLISP: Updated Heal Line/Polyline

Posted on November 12, 2014 by AutoCAD Tips

There were 2 posts from a while back that did the same thing – Erase a selected block and then heal the LINE or POLYLINE, but the annoying thing was that only one routine would work for LINES and you … Continue reading →

Posted in AutoLISP, AutoLISP: Blocks, AutoLISP: Modify, AutoLISP: Polylines, Modifying, Uncategorized | 2 Comments

AutoLISP: Heal – Erase Block & Heal Polyline

Posted on June 29, 2012 by AutoCAD Tips

Just like the previous post that heals lines, this routine will work on polylines. it will erase the selected block and then join the two polylines into one. Note: If the block is placed on a curved segment of a … Continue reading →

Posted in AutoLISP, AutoLISP: Blocks, AutoLISP: Modify, AutoLISP: Polylines, Blocks, Polylines | 4 Comments

AutoLISP: HEAL – Erase Block & Heal Line

Posted on June 29, 2012 by AutoCAD Tips

If you have blocks that lie upon a line and where they are on the line it has been trimmed, this routine might be of some use. this routine will let you simply select the block that rests on your … Continue reading →

Posted in AutoLISP, AutoLISP: Modify, Blocks | 1 Comment